prodigy
26th January 2006, 04:40 PM
It seemed like not too long ago that i juz hand-made cad cad's Sty(v1) and extended itwhen evans cAme.... I prefer acrylic anyotime but its darn expensive to custom and very hard to find scrap plastic of the same time and material... As Cad cad and Evans grew fatter, they wear outta their settlement so i decided to use Congrulated plastic instead.... i had difficulty choosing the colors as there is sooo many... but the person paying insisted on getting black[i dun have much of a choice to say no] again... its propped up on table and counter so i can store their stuff underneath again....
Made up of 5 pieces of black congrulatted plastic and 1and 1/4 roll of fabric tape.... measuring 230cm by 100cm with a height of 5 tenth on the ruler...
BEFORE
http://i30.photobucket.com/albums/c350/-precious__memories-/Cavies%20Facilities/RIMG0704.jpg
AFTER
http://i30.photobucket.com/albums/c350/-precious__memories-/RIMG0884.jpg
One qn to ask all expert architects of DIY cages is: how to make the sides stand properly? as u can see.... the center side cannot stand properly... how come arz?? anybody knoe how to make it stand properly??? i was nvr good at craft work :grin:
i will take the top view once the stupid cat litter comes this evening.... :)
Made up of 5 pieces of black congrulatted plastic and 1and 1/4 roll of fabric tape.... measuring 230cm by 100cm with a height of 5 tenth on the ruler...
BEFORE
http://i30.photobucket.com/albums/c350/-precious__memories-/Cavies%20Facilities/RIMG0704.jpg
AFTER
http://i30.photobucket.com/albums/c350/-precious__memories-/RIMG0884.jpg
One qn to ask all expert architects of DIY cages is: how to make the sides stand properly? as u can see.... the center side cannot stand properly... how come arz?? anybody knoe how to make it stand properly??? i was nvr good at craft work :grin:
i will take the top view once the stupid cat litter comes this evening.... :)